Home Baja Bumper Air Filter Oil Pressure Sender Front Suspension
Heater Blower Gauges Distributor Starter Relay
Bug Door Door Vapor Barrier Heat Riser Weber Carburetor
Clock Wiper Motor Oil Pump and Filter Rear Spring Plates

I turned a VW Beetle into a Baja daily driver. The project worked well, but rust repairs were more work than I was prepared for, so after all this, I sold the Beetle. The take-away lesson: start your project with a rust free vehicle, or be prepared to spend a zillion hours replacing rusty panels.

A kind reader Walt (Thanks Walt!) wrote with the solution to his brake system not bleeding as expected. The key to a good solid brake pedal is to have the brake shoes adjusted tight during the bleeding process. Even after bleeding, the shoes should drag on the drums just a tiny bit. It is true for nearly all cars with drum brakes that the shoes should drag lightly.

If your brake drums have a lip (as mine do) the shoes will drag on the lip, but when the brakes are applied, the shoes will press against the drum. This will give you a soft pedal. Your drums should not have a lip. If they do, you need to have the drums turned. When the drums reach some minimal thickness, you cannot turn them and must replace them. VW Bug rear drums are kind of pricy, and the wheel bearings have to be replaced as well.

Back in 2001 (or was it 2000?) I replaced the front brake hoses, wheel cylinders (slave cylinders), and brake shoes. The brake hoses were not clogged, but the driver side wheel cylinder had been leaking for some time, and so those shoes were coated in brake fluid and totally ineffective. No wonder the car pulled to the right during braking! I still need to have my rear drums turned to remove the lip.

Master Cylinder replaced.

This job was more work than expected, but the brakes are now really good! Photos and more text coming.
VW Golf seats make a HUGE difference in comfort. The passenger seat has aftermarket seat rails from Latest Rage. Very nice product priced around $75 for the pair of seat rails. I haven't gotten around to installing the new seat rail for the driver's seat (my original attempt was crude - just buy the seat rails and save yourself about 15 hours of work). Seats were between $25 and $50 from a junkyard. The passenger seat here is actually out of my Golf; I put a nicer seat from the junkyard into the Golf. I had to cut the padding on the right side of the driver's seat so the shifter will go into reverse when the seat is forward. The Golf seats can be fitted with a simple bit of cable to make them fold forward for back seat access. (photos later).

No carpet, and the floor has some surface rust. Rear floor is rusted through in spots. Note the nasty hole rusted behind the door. Don't buy a Bug with this rust.(click image for enlarged view)