PIAA Bracket on R1100RT
In this side view, we see the wire going into the vent. There was just enough room to push the wire outside the vent plumbing. On the left side of the bike there was a gap. On the right side, I had to pry a little to make an opening. This wire routing is somewhat unobtrusive. However, it depends on gaps in the vent. It also pinches the wire and could eventually cause a break. If you like this route in general, I suggest some modification that prevents the wire from being pinched. Perhaps it is possible to drill a hold in the vent. As I suggest above, removing the dashboard is a good idea. With the dash off you could find a better route for the wire.
